About this deal
The rest of the plastic webbing and the front wall can be trimmed away with a combination of flush cutters, end-nippers, and a hobby knife.
By accepting all cookies, you agree to our use of cookies to deliver and maintain our services and site, improve the quality of Reddit, personalize Reddit content and advertising, and measure the effectiveness of advertising. You can tape them in place, make a paper, putty, or foam model of the blaster to stick them onto (a la Bobololo), or you can do what I did and put them in a parts organizer bin in the rough location of where they came from on the blaster. Flip it over and with a single drop of blue thread locker on each screw, install all four cage screws.Take the positive lead down the grip and solder to the second (normally open) terminal of the rev switch.
Stretch the large bit of heat shrink and also shrink that over the connector to provide further protection and strain relief. The scope is not easy to look through, as it is too low for the user to look through while shouldering the blaster comfortably. Thread the XT-60 connector into the battery compartment and clamp the shell back together, making sure that both triggers still move freely as designed. It also features an integrated scope and three tactical rails: one on top of the scope and one on each side of the blaster.If you experience any jams or malfunctions, unplug your LiPo and diagnose the problem before continuing.